Special Tools
WARNING: This page is about a different car, the 2022 Cadillac CT4. However, it is still accessible from the selected car via links, so may be relevant.
GE-8001 Dial Indicator Set
Equivalent regional tools: Special Tools
- Inspect the outer tie rod seal. If the outer tie rod seal is torn, replace the outer tie rod. Steering Linkage Outer Tie Rod Replacement
- Raise the side of the vehicle being inspected with a floor jack while maintaining contact between the opposite wheel and the shop floor. Support the lower control arm with a floor jack stand as far outboard as possible and remove the floor jack. Lifting and Jacking the Vehicle
Install the GE-8001 Dial Indicator Set (1) between the outer tie rod (3) and the steering knuckle (2) as shown in the graphic. The tire and wheel assembly is shown removed only for clarity of the GE-8001 Dial Indicator Set mounting.
Grasping the tire at the 3 o'clock (2) and 9 o'clock (1) positions, gently push in on one side of the tire to remove any lash.
- Zero the GE-8001 Dial Indicator Set.
- On the same side of the tire previously pushed inwards, gently pull outwards and measure the lash.
- Record the measurement shown on the GE-8001 Dial Indicator Set.
- If the measured value exceeds 0.5 mm (0.02 in), replace the outer tie rod. Steering Linkage Outer Tie Rod Replacement
- Repeat the procedure for the other side.
NOTE:
This inspection procedure does not supersede local government required inspections that have more stringent requirements.