LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2021 >> CT4 Sport, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 101 (Transmission Cooling System) >> Repair Instructions >> Transmission Cooler Bypass Valve Replacement (L3B, RWD) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2022 Cadillac CT4. However, it is still accessible from the selected car via links, so may be relevant.
  1. GM5417058Courtesy of GENERAL MOTORS COMPANY

    Transmission Cooler Bypass Valve (2) - Install

    2. CAUTION:

    Refer to Fastener Caution .

  2. Transmission Fluid Cooler Thermal Bypass Valve Bolt (1) - Install and tighten - Fastener Specifications 
  3. GM5484121Courtesy of GENERAL MOTORS COMPANY

    Transmission Fluid Cooler Thermal Bypass Valve Gasket (1) - Install NEW [2x]

  4. GM5417056Courtesy of GENERAL MOTORS COMPANY
    NOTE:

    Remove the caps from the fittings and plugs from the holes before installing the transmission fluid cooler pipes.

    Transmission Fluid Cooler Inlet and Outlet Pipe (2) @ Transmission Cooler Bypass Valve - Install

  5. Transmission Fluid Cooler Pipe Nut (1) - Install and tighten - Fastener Specifications 
  6. Lower the vehicle.
  7. GM5484112Courtesy of GENERAL MOTORS COMPANY

    Transmission Fluid Cooler Thermal Bypass Valve Gasket (1) - Install NEW [2x]

  8. GM5417057Courtesy of GENERAL MOTORS COMPANY
    NOTE:

    Remove the caps from the fittings and plugs from the holes before installing the transmission fluid cooler pipes.

    Transmission Fluid Cooler Inlet and Outlet Pipe (3) @ Transmission Cooler Bypass Valve - Install

  9. Transmission Fluid Cooler Pipe Nut (2) - Install and tighten - Fastener Specifications 
  10. Transmission Fluid Cooler Pipe Clip Bolt (1) - Install and tighten - Fastener Specifications 
  11. GM5398967Courtesy of GENERAL MOTORS COMPANY

    Air Cleaner Outlet Duct (1) - Install

  12. Connect the electrical connector.
  13. GM5398955Courtesy of GENERAL MOTORS COMPANY

    Positive Crankcase Ventilation Tube (3) - Connect - Plastic Collar Quick Connect Fitting Service

  14. Evaporative Emission Canister Purge Tube (2) - Connect - Plastic Collar Quick Connect Fitting Service
  15. Air Cleaner Outlet Duct Clamp (1) - Tighten [2x] -
  16. GM5432174Courtesy of GENERAL MOTORS COMPANY

    Intake Manifold Cover (1) @ Upper Intake Manifold Bracket (2) - Install

  17. GM5432171Courtesy of GENERAL MOTORS COMPANY

    Push down on the front of the intake manifold cover (2).

  18. Intake Manifold Cover Bolt (1) - Install and tighten [2x] - Fastener Specifications
  19. Install the oil fill cap.
  20. Check the transmission fluid level. Transmission Fluid Level and Condition Check
  21. Inspect for transmission fluid leaks. Fluid Leak Diagnosis
scientia non olet · About LEMON Manuals