Removal Procedure

WARNING: This page is about a different variant/trim than selected.

Remove the transmission. Transmission Replacement (All Wheel Drive) , or Transmission Replacement (Rear Wheel Drive)
Courtesy of GENERAL MOTORS COMPANY

Install the EN-52476 Flywheel Holding Tool (1) through the starter mounting hole.
Courtesy of GENERAL MOTORS COMPANY

Automatic Transmission Flex Plate Bolt (1) - Remove and DISCARD [8x]
Automatic Transmission Flex Plate (2) - Remove
Courtesy of GENERAL MOTORS COMPANY

CAUTION:
Refer to Crankshaft Position Sensor Reluctor Ring Caution .

Crankshaft Position Sensor Reluctor Ring (1) - Remove
Flywheel Locating Pin (2) - Remove