Circuit/System Verification

WARNING: This page is about a different variant/trim than selected.

Ignition - On / Vehicle - In Service Mode
Verify DTC P0651 is not set.
- If the DTC is set
  Refer to DTC P0641, P0651, P0697, or P06A3
- Go to next step: If the DTC is not set
Engine - Idling
Verify DTC P30BE, P30BF, P30C2, P30C3, P30C6, P30C7, P30CA, P30CB is not set.
- If any of the DTCs are set
  Refer to: Circuit/System Testing
- Go to next step: If none of the DTCs are set
Perform the following action:
- Wiggle the harness and connector: B338 Intake Camshaft Profile Sleeve Position Sensor
- Wiggle the harness and connector: B339 Exhaust Camshaft Profile Sleeve Position Sensor
- Wiggle the harness and connector: K20 Engine Control Module
  Verify the DTC does not set.
- If the DTC sets
  Repair as necessary - Wiring / Terminal(s) / Electrical Connector(s)
- Go to next step: If the DTC does not set
Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.
Verify the DTC does not set.
- If the DTC sets
  Refer to: Circuit/System Testing
- Go to next step: If the DTC is not set
All OK.