Circuit/System Verification

WARNING: This page is about a different variant/trim than selected.

Ignition - On / Vehicle - In Service Mode
Verify no other DTCs are set.
- If other DTCs are set
  Refer to Diagnostic Trouble Code (DTC) List - Vehicle
- Go to next step: If no other DTCs are set
Verify the correct pressure: Fuel System Diagnosis
- If a condition exists
  Refer to: Circuit/System Testing
- Go to next step: If no condition exists
Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.
Verify the DTC does not set.
- If the DTC sets
  Refer to: Circuit/System Testing
- Go to next step: If the DTC does not set
All OK.