LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2021 >> CT4 Sport, 4WD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 10 (Automatic Transmission - 10L60 (MQA) - Diagnostic Information And Procedures) >> Diagnostic Information and Procedures >> DTC P18A2-P18A4 >> Component Testing

Component Testing

WARNING: This page is about a different variant/trim than selected.
  1. Ignition/Vehicle - Off
  2. Remove the component: Automatic Transmission Fluid Pan
  3. Disconnect the electrical connector: M123 Transmission Park Valve Lock Solenoid Actuator
  4. Test for 15 to 25 ohms between the test points: Control terminal 1 & Control terminal 2
    • If not between 15 and 25 ohms 

      Replace the component: M123 Transmission Park Valve Lock Solenoid Actuator

    • Go to next step: If between 15 and 25 ohms 
  5. Test for infinite resistance between the test points: Each terminal of the component & The component's housing
    • If less than infinite resistance 

      Replace the component: M123 Transmission Park Valve Lock Solenoid Actuator

    • Go to next step: If infinite resistance 
  6. All OK.