Installation Procedure

WARNING: This page is about a different car, the 2022 Cadillac CT4. However, it is still accessible from the selected car via links, so may be relevant.

Courtesy of GENERAL MOTORS COMPANY

Attach the mechanics wire to the new hood primary latch release cable (2) and guide the cable in.
Install the hood primary latch release cable grommet (1) to the dash panel.
Courtesy of GENERAL MOTORS COMPANY

Remove the mechanics wire from the hood primary latch release cable.
Attach the hood primary latch release cable end retainer to the inside handle (1).
Courtesy of GENERAL MOTORS COMPANY

Hood Primary Latch Release Cable (3) - Install
Hood Primary and Secondary Latch (2) - Install
Align marks to hood primary and secondary latch.
Hood Primary and Secondary Latch Bolt (1) - Install and tighten [2x] - Fastener Specifications
Courtesy of GENERAL MOTORS COMPANY

Air Inlet Grille Panel (2) - Install
Connect the windshield washer nozzle hose to the windshield washer pump hose.
Air Inlet Grille Panel Retainer (1) - Install [6x]
Courtesy of GENERAL MOTORS COMPANY

NOTE:
Left side shown, right side similar.

Front Compartment Side Sight Shield- Left Side and Right Side (2) - Install [2x]
Front Compartment Side Sight Shield Retainer (1) - Install [6x]
Courtesy of GENERAL MOTORS COMPANY

NOTE:
Left side shown, right side similar.

Air Inlet Grille Panel Extension- Outer- Left Side and Right Side (2) - Install [2x]
Air Inlet Grille Panel Retainer- Left Side and Right Side (1) - Install [4x]
Courtesy of GENERAL MOTORS COMPANY

NOTE:
Left side shown, right side similar.

Hood Rear Outer Air Inlet Seal- Left Side and Right Side (2) - Install [2x]
1. Hood Rear Outer Air Inlet Seal Retainer - Left Side and Right Side (1) - Install [2x]
2. Hood Rear Outer Air Inlet Seal - Left Side and Right Side (2) - Install [2x]
Courtesy of GENERAL MOTORS COMPANY

NOTE:
Left side shown, right side similar.

Air Inlet Grille Panel Extension- Left Side and Right Side (1) - Install [2x]
1. Install the 2 left and right side air inlet grille panel extension (1).
2. Remove the masking tape from the top edge of the left and right side service parts.
3. Using a 50/50 mixture of isopropyl alcohol and clean drinkable water with a clean towel, remove any left over adhesive residue from the masking tape.
Courtesy of GENERAL MOTORS COMPANY

NOTE:
Left side shown, right side similar.

Windshield Wiper Arm- Left Side and Right Side (3) - Install [2x]
1. Clean the left and right side windshield wiper transmission pivot shaft splines with a soft wire brush before installing the windshield wiper arm (3).
2. Position the left and right side windshield wiper arm (3) on the windshield wiper transmission pivot shaft.
3. Windshield Wiper Arm Nut- Left Side and Right Side (2) - Install and tighten [2x] - Fastener Specifications
4. Windshield Wiper Arm Finish Cap- Left Side and Right Side (1) - Install [2x]
Courtesy of GENERAL MOTORS COMPANY

If required, realign the left side and right side windshield wipers to their respective alignment circles (1) on the windshield.
1. Lubricate the windshield with clean washer fluid.
2. Run the windshield wipers for two complete cycles then turn off the windshield wipers.
3. Ensure the windshield wipers are in the full park position.
4. Inspect the windshield wipers for proper position to the alignment circles (1) on the windshield.