Removal Procedure
WARNING: This page is about a different car, the 2022 Cadillac CT4. However, it is still accessible from the selected car via links, so may be relevant.
- NOTE:
Left side shown, right side similar.
Windshield Wiper Arm- Left Side and Right Side (3) - Remove [2x]
- Using the appropriate trim tool, remove the 2 left side and right side windshield wiper arm finish caps (1) from the windshield wiper arm (3).
- Windshield Wiper Arm Nut- Left Side and Right Side (2) - Remove [2x]
- Grasp the outer end of the windshield wiper arm (3) and gently rock the arm back and forth to remove it from the windshield wiper transmission pivot shaft.
- NOTE:
Left side shown, right side similar.
Air Inlet Grille Panel Extension- Left Side and Right Side (1) - Remove [2x]
- Remove the 2 left side and right side air inlet grille panel extension (1) from the air inlet grille panel and upper front fender.
- Using a suitable plastic trim tool, carefully release the left side and right side air inlet grille panel extension clips.
- Apply two layers of masking tape around the top edge of the left side and right side service part to prevent paint damage.
- NOTE:
Left side shown, right side similar.
Hood Rear Outer Air Inlet Seal- Left Side and Right Side (2) - Remove [2x]
- Hood Rear Outer Air Inlet Seal Retainer - Left Side and Right Side (1) - Remove [4x]
- Hood Rear Outer Air Inlet Seal - Left Side and Right Side (2) - Remove [2x]
- NOTE:
Left side shown, right side similar.
Front Compartment Side Sight Shield Retainer- Left Side and Right Side (1) - Remove [6x]
- Front Compartment Side Sight Shield- Left Side and Right Side (2) - Remove [2x]
- NOTE:
Left side shown, right side similar.
Air Inlet Grille Panel Retainer- Left Side and Right Side- Left Side and Right Side (1) - Remove [4x]
- Air Inlet Grille Panel Extension- Outer (2) - Remove [2x]
Air Inlet Grille Panel Retainer (1) - Remove [6x]
- Disconnect the windshield washer nozzle hose from the windshield washer pump hose.
- Lift the front edge of the air inlet grille panel (2) and slide the panel forward from both hood hinges to remove.
Hood Hinge Nut (1) - Remove [4x]
- With the aid of an assistant, remove the hood (2).
Hood Hinge Bolt (1) - Remove [3x]
- Hood Hinge (2) - Remove