Installation Procedure

WARNING: This page is about a different car, the 2022 Cadillac CT4. However, it is still accessible from the selected car via links, so may be relevant.

Courtesy of GENERAL MOTORS COMPANY

Engage the multifunction power supply converter (1) into the multifunction power supply converter bracket (2).
Connect the electrical connector.
Courtesy of GENERAL MOTORS COMPANY

Install the multifunction power supply converter bracket (3), into position.

CAUTION:

Refer to Fastener Caution

Multifunction Power Supply Converter Bracket Bolt(4) - Install and tighten[2x] - Fastener Specifications
Retainer(1) - Engage[3x]
Electrical Connector(2) - Connect
Courtesy of GENERAL MOTORS COMPANY

NOTE:
Carefully manipulate the deck lid hinge opening of the rear compartment side trim past the hinge cover.

Rear Compartment Side Trim-Left Side(2) - Install
Rear Compartment Side Trim Insulator Retainer (1) - Install[3x]
Courtesy of GENERAL MOTORS COMPANY

Rear End Trim Finish Panel(1) - Install
Courtesy of GENERAL MOTORS COMPANY

Rear End Trim Finish Panel Opening Cover(1) - Install
Courtesy of GENERAL MOTORS COMPANY

Rear Compartment Floor Panel Trim(1) - Install
Courtesy of GENERAL MOTORS COMPANY

Cargo Tie Down Loop(3) - Install[2x]
Cargo Tie Down Loop Bolt(2) - Install and tighten[2x] - Fastener Specifications
Cargo Tie Down Loop Bolt Cap(1) - Install[2x]