Installation Procedure

WARNING: This page is about a different car, the 2022 Cadillac CT4. However, it is still accessible from the selected car via links, so may be relevant.

Courtesy of GENERAL MOTORS COMPANY

Install the generator (1) with the lower generator mounting bolt (2).
Courtesy of GENERAL MOTORS COMPANY

CAUTION:
Refer to Fastener Caution

Generator Bolt(2) - Install and tighten - Fastener Specifications
Generator Bolt(1) - Install and tighten - Fastener Specifications
Courtesy of GENERAL MOTORS COMPANY

NOTE:
Intake manifold is shown transparent.

Auxiliary Generator Battery Jumper Cable(2) - Install
Battery Positive Cable Nut(1)@Generator - Install and tighten - Fastener Specifications
Courtesy of GENERAL MOTORS COMPANY

Electrical Connector(1) - Connect
Courtesy of GENERAL MOTORS COMPANY

Radiator Inlet Hose Bracket(2) - Install
Radiator Inlet Hose Bracket Bolt(1) - Install and tighten - Fastener Specifications
Courtesy of GENERAL MOTORS COMPANY

Charge Air Cooler Outlet Air Tube(2)@Throttle Body - Install
Retainer Spring(1) - Engage
Courtesy of GENERAL MOTORS COMPANY

Drive Belt Tensioner(2) - Install
Drive Belt Tensioner Bolt(1) - Install and tighten - Fastener Specifications
Courtesy of GENERAL MOTORS COMPANY

Using an appropriate tool, rotate the drive belt tensioner (1) counterclockwise and hold tension.
Courtesy of GENERAL MOTORS COMPANY

Accessory Drive Primary Belt(1) - Install
Slowly release tension on the accessory drive primary belt.
Courtesy of GENERAL MOTORS COMPANY

Intake Manifold Cover(1)@Upper Intake Manifold Bracket(2) - Install
Courtesy of GENERAL MOTORS COMPANY

Install the intake manifold cover (1).
Install the oil fill cap.
Connect the battery negative cable. Battery Negative Cable Disconnection and Connection