Terminal Removal Procedure

WARNING: This page is about a different car, the 2022 Cadillac CT4. However, it is still accessible from the selected car via links, so may be relevant.

Courtesy of GENERAL MOTORS COMPANY

Using the tip of the screwdriver (1) insert the tool into the release tab (2), lift the latch of the wire cover (3). Raise the cover (4) and rotate the wire cover (5) to remove it from the connector housing.
Courtesy of GENERAL MOTORS COMPANY

Open the TPA by inserting a small screwdriver (1) into the bottom of the cutout of the terminal block (2). Gently pry the outside of the TPA away from the connector housing (3).

1.2 Terminals

Courtesy of GENERAL MOTORS COMPANY

Insert tip of removal tool J-38125-214 (1) into the opening above the circuit cavity (2) to deflect the terminal lock. Once the locking tab has been deflected, gently pull of the wire to remove it from the connector housing.

2.8 Terminals

Courtesy of GENERAL MOTORS COMPANY

Insert the tip of removal tool J-38125-557 (1) into the openings above and below (2) the circuit cavity to deflect the terminal locking tab. Once the locking lance has been deflected, gently pull of the wire to remove it from the connector housing.