Connector Removal Procedure
WARNING: This page is about a different car, the 2022 Cadillac CT4. However, it is still accessible from the selected car via links, so may be relevant.
To disconnect the connector from the component, push the CPA away from the wire bundle, then press the primary latch on the top of the connector to release the lever arm from the connector.
Push the lever away from the wire bundle.
Push the lever away from the wire bundle. The lever must be pushed all the way forward before it can be removed from the component
While pushing forward on the lever (1), grip the back of the harness and evenly pull straight upwards (2) and away from the module.