LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2021 >> CT4 Sport, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 87 (Lighting System - Diagnostic Information And Procedures (2 Of 2)) >> Diagnostic Information and Procedures >> DTC C10A1 >> Circuit/System Testing

Circuit/System Testing

WARNING: This page is about a different car, the 2022 Cadillac CT4. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition OFF, disconnect the connector at the B162R Vertical Body Acceleration Sensor - Rear, ignition ON.
  2. Verify a test lamp illuminates between low reference circuit terminal 2 and B+.
    • If the test lamp does not illuminate 
    1. Test circuit 2185 for an open/high resistance.
      • If an open/high resistance is found, repair the fault on the circuit.
      • Go to next step: If an open/high resistance is not found.
    2. Replace the E13LA Headlamp Assembly - Left.
    • Go to next step: If the test lamp illuminates 
  3. Test for 4.8 V - 5.2 V between the 5 V reference terminal 1 and ground.
    • If less than 4.8 V 
    1. Test circuit 2165 for a short to ground.
      • If a short to ground is found, repair the fault on the circuit.
      • Go to next step: If a short to ground is not found
    2. Test circuit 2165 for an open/high resistance.
      • If an open/high resistance is found, repair the fault on the circuit.
      • Go to next step: If an open/high resistance is not found.
    3. Replace the E13LA Headlamp Assembly - Left.
    • If greater than 5.2 V 
    1. Test circuit 2165 for a short to voltage.
      • If a short to voltage is found, repair the fault on the circuit.
      • Go to next step: If a short to voltage is not found.
    2. Replace the E13LA Headlamp Assembly - Left.
    • Go to next step: If 4.8 V - 5.2 V 
    1. Test circuit 2184 for an open/high resistance.
      • If an open/high resistance is found, repair the fault on the circuit.
      • Go to next step: If an open/high resistance is not found.
    2. Test circuit 2184 for a short to ground.
      • If a short to ground is found, repair the fault on the circuit.
      • Go to next step: If a short to ground is not found
    3. Test circuit 2184 for a short to voltage.
      • If a short to voltage is found, repair the fault on the circuit.
      • Go to next step: If a short to voltage is not found.
  4. Replace the B162R Vertical Body Acceleration Sensor - Rear.
  5. Verify the DTC does not set while operating the vehicle within the conditions for running the DTC.
    • If the DTC sets 

      Replace the E13LA Headlamp Assembly - Left

    • Go to next step: If the DTC does not set 
  6. All OK.