Removal Procedure

WARNING: This page is about a different car, the 2022 Cadillac CT4. However, it is still accessible from the selected car via links, so may be relevant.

Place a clean suitable drain pan under the windshield washer solvent container to recover the windshield washer solvent.
Courtesy of GENERAL MOTORS COMPANY

Windshield Washer Solvent Container Filler Tube Bracket Bolt (1) - Remove
While twisting, pull inboard on the windshield washer solvent container filler tube (2) to remove it from the windshield washer solvent container grommet.
Remove the right front tire and wheel assembly. Tire and Wheel Removal and Installation
Courtesy of GENERAL MOTORS COMPANY
NOTE:
- Quantity of fasteners may vary based on option content.
Engine Front Splash Shield Retainer - Right Side (2) - Remove
Engine Front Splash Shield Bolt - Right Side (1) - Remove [4x]
Engine Front Splash Shield - Right Side (3) - Remove
Courtesy of GENERAL MOTORS COMPANY

NOTE:
Left side shown, right side similar.

Front Wheelhouse Liner Bolt - Right Side (1) - Remove [3x]
Rocker Panel Protector - Right Side (2) - Remove
Courtesy of GENERAL MOTORS COMPANY

NOTE:
Left side shown, right side similar.

Front Bumper Fascia Air Deflector Bolt - Right Side (1) - Remove [4x]
Front Bumper Fascia Air Deflector - Right Side - Outer (2) - Remove
Courtesy of GENERAL MOTORS COMPANY

NOTE:
Left side shown, right side similar.

Front Wheelhouse Liner Retainer - Right Side (1) - Remove [3x]
Front Wheelhouse Liner Bolt - Right Side (2) - Remove [9x]
Front Wheelhouse Liner - Right Side (3) - Remove
Courtesy of GENERAL MOTORS COMPANY

Disconnect the electrical connectors.
Release the windshield washer solvent container wiring harness retainers (1) and reposition the windshield washer solvent container wiring harness as necessary.
Windshield Washer Pump Hose (2) - Disconnect and reposition
Courtesy of GENERAL MOTORS COMPANY

NOTE:
Support the windshield washer solvent container while removing the windshield washer solvent container bolts.

Windshield Washer Solvent Container Bolt (1) - Remove [2x]
Windshield Washer Solvent Container (2) - Remove
Courtesy of GENERAL MOTORS COMPANY

Using two flat-bladed tools, place the blades under each side of the windshield washer pump (1).
Twist the two flat-bladed tools in opposite directions to lift and disengage the windshield washer pump (1) from the windshield washer pump grommet (2).
Carefully squeeze the windshield washer pump grommet (2) while using a flat-bladed tool to pry outward under the edge of the grommet to remove it from the windshield washer solvent container.