Installation Procedure

WARNING: This page is about a different car, the 2022 Cadillac CT4. However, it is still accessible from the selected car via links, so may be relevant.

Courtesy of GENERAL MOTORS COMPANY

Center Pillar Lower Trim Panel (1) - Install
Courtesy of GENERAL MOTORS COMPANY

CAUTION:
Refer to Fastener Caution .

Front Seat Belt Anchor Plate Tensioner Bolt- Upper (2) - Install and tighten - Fastener Specifications
Front Seat Belt Anchor Plate Tensioner Cover (1) - Install
Courtesy of GENERAL MOTORS COMPANY

Rear Side Door Sill Garnish Molding (1) - Install
Courtesy of GENERAL MOTORS COMPANY

Rear Seat Back Bolster (2) - Install
Rear Seat Back Bolster Nut (1) - Install and tighten - Fastener Specifications
Courtesy of GENERAL MOTORS COMPANY

Slide the rear seat back bolster retainer lock (1) toward the rear of the vehicle.
Courtesy of GENERAL MOTORS COMPANY

Rear Seat Cushion (1) - Install - Rear Seat Cushion Removal and Installation
Courtesy of GENERAL MOTORS COMPANY

NOTE:
Reposition the front floor panel carpet as needed.

Starting at the front of the front side door sill garnish molding (1), engage the clip on the forward vertical wall and locator pin.
Work your way rearward engaging all the front side door sill garnish molding clips.
Front Side Door Sill Garnish Molding (1) - Install
Courtesy of GENERAL MOTORS COMPANY

{ If equipped } Connect the electrical connector.
Instrument Panel Outer Trim Cover (1) - Install
Enable the SIR System. SIR Disabling and Enabling