Removal Procedure
WARNING: This page is about a different car, the 2022 Cadillac CT4. However, it is still accessible from the selected car via links, so may be relevant.
Rear Bumper Fascia (1) - Remove - Rear Bumper Fascia Removal and Installation (without Blackwing) , or Rear Bumper Fascia Removal and Installation (with Blackwing)
- Reposition the wiring harness.
- Disconnect the electrical connector from the low frequency rear bumper antenna.
- Disconnect the rear parking sensor electrical connector
Rear Bumper Fascia Energy Absorber Clip (1) - Remove [4x]
- Rear Bumper Fascia Energy Absorber Bolt (2) - Remove [2x]
- Rear Bumper Fascia Energy Absorber (3) - Remove
Drill out the 2 exhaust tail pipe heat sleeve rivets on the left and right side of the rear bumper fascia (1).
- Rear Bumper Fascia Bolt (2) - Remove [2x]
- Exhaust Tail Pipe Heat Sleeve (3) - Remove [2x]
Remove the 3 left and right side rear fascia signal lamp bolts (1).
- Remove the 2 rear fascia signal lamps from the left and right side (2).
Rear Bumper Fascia Bolt (1) - Remove [2x]
- Release the retainer tabs on the rear bumper lower fascia (2) and remove from the upper fascis.