Removal Procedure

WARNING: This page is about a different car, the 2022 Cadillac CT4. However, it is still accessible from the selected car via links, so may be relevant.

Raise and support the vehicle. Lifting and Jacking the Vehicle
Courtesy of GENERAL MOTORS COMPANY

NOTE:
Left side shown, right side similar.

Rear Wheelhouse Liner Bolt- Left Side and Right Side (1) Remove [8x]
Courtesy of GENERAL MOTORS COMPANY

NOTE:
Left side shown, right side similar.

Rear Bumper Fascia Bolt- Left Side and Right Side (1) Remove [10x]
Courtesy of GENERAL MOTORS COMPANY

NOTE:
Left side shown, right side similar.

Rear Bumper Fascia Bolt- Left Side and Right Side (1) Remove [2x]
Courtesy of GENERAL MOTORS COMPANY

NOTE:
Left side shown, right side similar.

Rear Bumper Fascia Bolt- Left Side and Right Side (1) Remove [2x]
Courtesy of GENERAL MOTORS COMPANY

Rear Bumper Fascia Bolt (1) Remove [3x]
Courtesy of GENERAL MOTORS COMPANY

NOTE:
Right side shown, left side similar.

Carefully push a small nylon wedge between the fascia (1) and the fascia guide. Insert a small flat-bladed tool into the fascia slot and depress the snaps one at a time and pull on the fascia at the same time to gradually remove the fascia from the left and right side.
Courtesy of GENERAL MOTORS COMPANY

NOTE:
Left side shown, right side similar.

Release the 6 left and right side rear bumper fascia retainer clips (1) from the rear bumper fascia reinforcements.
Courtesy of GENERAL MOTORS COMPANY

With the aid of an assistant, remove the fascia. (1)
Disconnect all electrical connectors.