Removal Procedure
Rear Seat Back Cushion (1) - Remove - Rear Seat Back Cushion Removal and Installation (60 Percent Seat) , or Rear Seat Back Cushion Removal and Installation (40 Percent Seat)
- NOTE:
Left side shown, right side similar.
Depress the large button on the head restraint guide and raise the head restraint (1) to the full up position.
- Using an appropriate tool, insert into the small hole on the second rear seat head restraint guide to release the rear seat head restraint.
- Pull upward on the rear seat head restraint to remove from the rear seat.
Using a suitable flat-bladed tool, slide the tool on the outside of the rear seat head restraint guide (1) until it finds the slot. Then push the plastic slot inward and pull upward to remove the guide from the seat back frame.
- NOTE:
Left side shown, right side similar.
Use a thin flat-bladed tool to release the retainers.
- Rear Seat Back Latch Release Handle Bezel (1) - Remove
Rear Seat Back Outer Pivot Bolt (1) - Remove
- Rear Seat Back Hinge Bushing (2) - Remove
- Rear Seat Back Cushion Outer Pivot Bolt Spring (3) - Remove
- Rear Seat Recliner Outer Finish Cover (4) - Remove
Rear Seat Back Panel (1) - Remove
Reposition the seat back cushion cover as needed.
- Rear Seat Armrest Hinge Finish Cover (1) - Remove
- Rear Seat Armrest Bolt (2) - Remove [2x]
- Rear Seat Armrest Clip (3) - Remove
- Remove the rear seat armrest hinge finish bracket (4) from the rear seat armrest (5).
Lower the rear seat armrest about three quarters the way down.
- Using an appropriate flat-bladed tool, gently pry outwards on the inboard armrest hinge cover (1) retaining tab.
- Lift up on the rear of the armrest to disengage the rear seat armrest retaining pin.
- Rear Seat Armrest (2) - Remove
Loosen the rear seat cushion cover and pad (1, 2) from the rear seat back frame.
- Remove the hog rings from the under side of the seat cushion.
- Pull the cushion cover (1) from the cushion pad (2).