Installation Procedure

WARNING: This page is about a different car, the 2022 Cadillac CT4. However, it is still accessible from the selected car via links, so may be relevant.

Courtesy of GENERAL MOTORS COMPANY

Front Seat Cushion Frame (3) - Install

NOTE:

The new cushion frame may not have adjuster stops installed. Transfer the adjuster stops from original frame or install new as needed. The frame may need to be adjusted to access the adjuster stops.

Front Seat Adjuster Stop (2) - Install [2x]
If NEW threaded components are being installed, loosen the adhesive using a metal pick or similar tool before proceeding. If threaded components are reused, prepare the threaded components using the following steps:
1. Remove any loose cured adhesive from the external threads of the components using a lint free cloth.
2. Thread the cleaned components into the internal mating threads and remove to loosen trapped cured adhesive.
3. Apply thread locking adhesive to the external threads of the components. Adhesives, Fluids, Lubricants, and Sealers
4. Ensure there are no gaps in the thread locking adhesive once applied to the component.

CAUTION:

Refer to Fastener Caution .

Front Seat Upper Bolt (1) - Install and tighten [4x] - Fastener Specifications
Courtesy of GENERAL MOTORS COMPANY

Front Seat Lumbar Support (1) - Install
Courtesy of GENERAL MOTORS COMPANY

Front Seat Cushion Outer Finish Cover Support (1) - Install [2x]
Courtesy of GENERAL MOTORS COMPANY

Front Seat Adjuster Memory Module Bracket (2) - Install
Position the wiring harness.
Front Seat Adjuster Memory Module Bolt (1) - Install and tighten [4x] - Fastener Specifications
Courtesy of GENERAL MOTORS COMPANY

Front Seat Cushion Pad Support (1) - Install
Install the retainers.
Courtesy of GENERAL MOTORS COMPANY

Front Seat Cushion Cover Retainer - Power Sideshield (2) - Install
Front Seat Adjuster Finish Cover Bolt (1) - Install and tighten [2x] - Fastener Specifications
Courtesy of GENERAL MOTORS COMPANY

Front Seat Cushion Cover Retainer - Front Sideshield (2) - Install
Front Seat Adjuster Finish Cover Bolt (1) - Install and tighten [2x] - Fastener Specifications
Courtesy of GENERAL MOTORS COMPANY

Front Seat Belt Buckle (2) - Install
Connect the electrical connector and install the wiring harness retainers as necessary.
Front Seat Belt Buckle Bolt (1) - Install and tighten - Fastener Specifications
Courtesy of GENERAL MOTORS COMPANY

Front Seat Inner Recliner Finish Cover (1) - Install [2x]
Courtesy of GENERAL MOTORS COMPANY

Front Seat Adjuster Track Finish Cover - Outer (1) - Install
Courtesy of GENERAL MOTORS COMPANY

Front Seat Adjuster Track Finish Cover - Inner (1) - Install
Courtesy of GENERAL MOTORS COMPANY

Front Seat Cushion Cover and Pad (2) - Install - Front Seat Cushion Cover and Pad Removal and Installation , or Front Seat Cushion Cover and Pad Removal and Installation (Blackwing)