Component Testing
WARNING: This page is about a different car, the 2022 Cadillac CT4. However, it is still accessible from the selected car via links, so may be relevant.
- Ignition/Vehicle - Off
- Disconnect the electrical connector: B280 Automatic Transmission Accumulator Solenoid ValveNOTE:
The component's temperature should be 19 to 21°C (66 to 70°F) while testing.
- Test for 17 to 19 ohms between the test points: Control circuit terminal 1 & Control circuit terminal 2
- If not between 17 and 19 ohms
Replace the component: B280 Automatic Transmission Accumulator Solenoid Valve
- Go to next step: If between 17 and 19 ohms
- If not between 17 and 19 ohms
- Test for infinite resistance between the test points: Each terminal of the component & The component's housing
- If less than infinite resistance
Replace the component: B280 Automatic Transmission Accumulator Solenoid Valve
- Go to next step: If infinite resistance
- If less than infinite resistance
- All OK.