Circuit/System Verification
WARNING: This page is about a different car, the 2022 Cadillac CT4. However, it is still accessible from the selected car via links, so may be relevant.
- Engine - Running
- Verify the scan tool parameter:
- High Side Driver 2 Circuit High Test Status = Okay or Not Run
- High Side Driver 2 Circuit Low Test Status = Okay or Not Run
- High Side Driver 2 Circuit Open Test Status = Okay or Not Run
- Transmission Control Solenoid Valve 1, 2, 3, 6, 7, 9 Control Circuit High Test Status = Okay or Not Run
- Transmission Control Solenoid Valve 1, 2, 3, 6, 7, 9 Control Circuit Low Test Status = Okay or Not Run
- Transmission Control Solenoid Valve 1, 2, 3, 6, 7, 9 Control Circuit Open Test Status = Okay or Not Run
- If not the specified state
Refer to: Circuit/System Testing
- Go to next step: If the specified state
- Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.
Verify the DTC does not set.
- If the DTC sets
Refer to: Circuit/System Testing
- Go to next step: If the DTC is not set
- If the DTC sets
- All OK.