Removal Procedure

WARNING: This page is about a different car, the 2022 Cadillac CT4. However, it is still accessible from the selected car via links, so may be relevant.

Oil Filler Cap - Remove
Courtesy of GENERAL MOTORS COMPANY

Intake Manifold Cover Bolt (1) - Remove
Intake Manifold Cover (2) - Remove
Install the oil filler cap after removal of the intake manifold cover to prevent debris from falling into the engine.
Courtesy of GENERAL MOTORS COMPANY

Disconnect the turbocharger wastegate regulator solenoid valve electrical connector.
Turbocharger Wastegate Actuator Vacuum Tank Bolt (3) - Remove [2x]
Courtesy of GENERAL MOTORS COMPANY

Disconnect the turbocharger wastegate regulator solenoid valve electrical connector.
Turbocharger Wastegate Actuator Vacuum Tank Bolt (3) - Remove [2x]
Courtesy of GENERAL MOTORS COMPANY

Turbocharger Wastegate Actuator Vacuum Tank Solenoid Valve Tube (3) @ Auxiliary Air Cleaner Outlet Duct - Disconnect - Plastic Collar Quick Connect Fitting Service
Courtesy of GENERAL MOTORS COMPANY

Charge Air Bypass Valve Vacuum Tank Tube (3) - Disconnect - Plastic Collar Quick Connect Fitting Service
Courtesy of GENERAL MOTORS COMPANY

Turbocharger Wastegate Actuator Vacuum Source Tube (1) @ Camshaft Cover - Disconnect - Plastic Collar Quick Connect Fitting Service
Courtesy of GENERAL MOTORS COMPANY

Charge Air Bypass Valve Tube (1) @ Charge Air Bypass Valve - Disconnect - Plastic Collar Quick Connect Fitting Service
Courtesy of GENERAL MOTORS COMPANY

Electrical Connector (1) @ Charge Air Bypass Valve (2) - Disconnect
Courtesy of GENERAL MOTORS COMPANY

Charge Air Bypass Valve Tube (1) @ Charge Air Bypass Valve - Disconnect - Plastic Collar Quick Connect Fitting Service
Courtesy of GENERAL MOTORS COMPANY

Electrical Connector (1) @ Charge Air Bypass Valve (2) - Disconnect
Courtesy of GENERAL MOTORS COMPANY

Turbocharger Wastegate Actuator Vacuum Tank Bolt (1) - Remove [2x]
Turbocharger Wastegate Actuator Vacuum Tank (2) - Remove
Courtesy of GENERAL MOTORS COMPANY

Charge Air Bypass Valve Hose Clamp (1) - Loosen
Charge Air Bypass Valve Tube Connector Clamp (2) - Loosen
Charge Air Bypass Valve (3) - Remove
Courtesy of GENERAL MOTORS COMPANY

Charge Air Cooler Inlet Air Tube Bolt (1) - Remove [2x]
Charge Air Bypass Valve Tube Connector Clamp (2) - Loosen
Charge Air Cooler Inlet Pipe (3) - Remove
Charge Air Cooler Inlet Air Tube Seal (4) - Remove and DISCARD
Courtesy of GENERAL MOTORS COMPANY

CAUTION:
The Positive Crankcase Ventilation (PCV) line is tamper resistant and must always be replaced once it is removed. The fittings connected to the PCV line must also be replaced if they are damaged when the PCV line is removed. To reduce the risk of damage to the fittings, use a suitable cutting tool and carefully cut the connections away.

NOTE:
Some components not shown for graphic clarity.

Using a suitable cutting tool, carefully cut the 2 positive crankcase ventilation tube connectors (1).
Positive Crankcase Ventilation Foul Air Tube (2) - Remove and DISCARD
Courtesy of GENERAL MOTORS COMPANY

NOTE:
Replace only the components necessary to complete the repair.

Disconnect the ignition coil electrical connector.
Ignition Coil Bolt (1) - Remove
Ignition Coil (2) - Remove