Removal Procedure
WARNING: This page is about a different car, the 2022 Cadillac CT4. However, it is still accessible from the selected car via links, so may be relevant.
- The heated oxygen sensor in-line connector and louvered end MUST be kept clear of all grease, dirt, and other contaminants. Do NOT use cleaning solvents of any type. Do NOT drop or roughly handle the sensor.
- Raise and support the vehicle. Lifting and Jacking the Vehicle
- Disconnect and reposition electrical connectors as necessary.
- Using the EN-6179 Heated Oxygen Sensor Remover/Installer, remove the heated oxygen sensor (1).
WARNING:
In order to avoid being burned, do not service the exhaust system while it is still hot. Service the system when it is cool.
WARNING:
Avoid contact with HOT components. Wear safety glasses and protective gloves to avoid personal injury.
CAUTION:
Refer to Heated Oxygen and Oxygen Sensor Caution .
CAUTION:
The use of excessive force may damage the threads in the exhaust manifold/pipe.
NOTE: