LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2021 >> CT4 Sport, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 60 (Engine Controls And Fuel - 2.7L (L3B) - Repair Instructions) >> Repair Instructions >> Fuel Injection Pump Bracket Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2022 Cadillac CT4. However, it is still accessible from the selected car via links, so may be relevant.
  1. GM5478561

    Fuel Injection Pump Bracket (3) - Install

    2. CAUTION:

    Refer to Fastener Caution .

  2. Fuel Pump Shield Bolt (2) - Install and tighten [2x] - Fastener Specifications
  3. Fuel Pump Shield Bolt (1) - Install and tighten [2x] - Fastener Specifications
  4. GM5457786

    Upper Intake Manifold Bracket (2) - Install

  5. Upper Intake Manifold Cover Nut (1) - Install and tighten [2x] - Fastener Specifications
  6. GM5457857

    Radiator Surge Tank Inlet Hose Clip (2) @ Upper Intake Manifold Bracket (3) - Install

  7. Upper Intake Manifold Cover Nut (1) - Install and tighten [2x] - Fastener Specifications
  8. GM5457059

    Electrical Connector (1) - Connect as necessary

  9. GM5432174

    Intake Manifold Cover (1) @ Upper Intake Manifold Bracket (2) - Install

  10. GM5432171

    Push down on the front of the intake manifold cover (2).

  11. Intake Manifold Cover Bolt (1) - Install and tighten [2x] - Fastener Specifications
  12. Install the oil fill cap.
  13. Connect the battery negative cable. Battery Negative Cable Disconnection and Connection
scientia non olet · About LEMON Manuals