Removal Procedure
Intake Manifold Cover Bolt (1) - Remove [2x]
Intake Manifold Cover Insulator (1) - Remove
- Relieve the fuel system pressure. Fuel Pressure Relief
Fuel Feed Pipe (1) - Disconnect - Metal Collar Quick Connect Fitting Service
- Fuel Feed Pipe (1) @ Retainer (2) - Remove
- Raise and support the vehicle. Lifting and Jacking the Vehicle
Floor Panel Number 4 Cross Bar Reinforcement Bolt (1) - Remove [6x]
- Floor Panel Reinforcement (2) - Remove
Catalytic Converter Nut (1) - Remove [2x]
Electrical Connector (1) @ Exhaust Control Valve Actuator - Disconnect [2x]
Exhaust Muffler (1) @ Exhaust Intermediate Pipe Insulator-Left Side (2) - Separate
- Exhaust Muffler (1) @ Exhaust Rear Muffler Insulator-Left Side (3) - Separate
Exhaust Muffler (1) @ Exhaust Intermediate Pipe Insulator-Right Side (2) - Separate
- Exhaust Muffler (1) @ Exhaust Rear Muffler Insulator-Right Side (3) - Separate
Exhaust Muffler (1) - Remove
- Catalytic Converter Gasket (2) - Remove and DISCARD
Exhaust Heat Shield Bolt (1) - Remove [6x]
- Exhaust Intermediate Underbody Heat Shield (2) - Remove
Exhaust Heat Shield Bolt (1) - Remove
- Exhaust Heat Shield Nut (2) - Remove [3x]
- Exhaust Front Underbody Heat Shield (3) - Remove
Fuel Feed Pipe (1) @ Retainer (2) - Remove [2x]
Fuel Feed Pipe (1) @ Fuel Pump Fuel Feed Hose (2) - Disconnect - Plastic Collar Quick Connect Fitting Service
- Fuel Feed Pipe (1) @ Retainer (3) - Remove [4x]
- Fuel Feed Pipe (1) - Remove
Refer to Diesel/Gasoline Vapors Warning .
Refer to Safety Glasses Warning .