LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2021 >> CT4 Sport, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 59 (Engine Controls And Fuel - 2.0L (LSY) - Repair Instructions) >> Repair Instructions >> Intake Camshaft Profile Sleeve Position Sensor Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2022 Cadillac CT4. However, it is still accessible from the selected car via links, so may be relevant.
  1. GM5299805

    Camshaft Intake Lobe Sensor (2) - Install

    2. CAUTION:

    Refer to Fastener Caution .

  2. Camshaft Intake Lobe Sensor Bolt (1) - Install and tighten - Fastener Specifications
  3. Connect the electrical connector to the camshaft intake lobe sensor.
  4. GM5335089

    Intake Manifold Cover (1) @ Upper Intake Manifold Bracket (2) - Install

  5. GM5335087
    NOTE:

    Ensure the intake manifold cover fully engages the intake manifold cover studs.

  6. Push down on the front of the intake manifold cover (1) as indicated.
  7. Install the oil fill cap.
scientia non olet · About LEMON Manuals