LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2021 >> CT4 Sport, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 58 (Hydraulic Brakes - Repair Instructions) >> Repair Instructions >> Rear Brake Hose Replacement (J6G) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2022 Cadillac CT4. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise and support the vehicle. Lifting and Jacking the Vehicle
  2. Remove the rear tire and wheel assembly. Tire and Wheel Removal and Installation
  3. GM5892383

    { If equipped } Wiring Harness Retainer (2) - Disengage

  4. { If equipped } Rear Disc Brake Pad Wear Sensor (1) @ Wiring Harness Retainer (2) - Remove
  5. Wiring Harness Retainer (4) - Disengage
  6. Rear Wheel Speed Sensor (3) @ Wiring Harness Retainer (4) - Remove
  7. GM5892385

    Rear Brake Hose Clip Bolt (1) - Remove [2x]

  8. Rear Brake Pipe Nut (2) - Remove
  9. Rear Brake Pipe Clip (3) - Remove
  10. Cap the rear brake pipe outlet to prevent brake fluid loss and contamination.
  11. GM5892384

    Rear Brake Hose Fitting (1) - Remove

  12. Rear Brake Hose Fitting Gasket (3) - Remove and DISCARD [2x]
  13. Rear Brake Hose (2) @ Rear Brake Caliper - Remove
  14. Plug the rear brake caliper inlet to prevent brake fluid loss and contamination.
  15. GM5892388

    Rear Brake Hose (1) - Remove

scientia non olet · About LEMON Manuals