Removal Procedure
- Raise and support the vehicle. Lifting and Jacking the Vehicle
- Remove the right rear tire and wheel assembly. Tire and Wheel Removal and Installation
Rear Tire Front Air Deflector Bolt- Left Side and Right Side (1) - Remove [4x]
- Rear Tire Front Air Deflector- Left Side and Right Side (2) - Remove [2x]
Rear Wheelhouse Liner Bolt- Left Side (1) - Remove
- Underbody Rear Air Deflector Nut- Left Side (2) - Remove [3x]
- Underbody Rear Air Deflector Bolt- Left Side (3) - Remove [3x]
- Underbody Rear Air Deflector Nut- Left Side (4) - Remove [2x]
- Underbody Rear Air Deflector- Left Side (5) - Remove
Rear Wheelhouse Liner Bolt- Right Side (1) - Remove
- Underbody Rear Air Deflector Bolt- Right Side (2) - Remove [3x]
- Underbody Rear Air Deflector Nut- Right Side (3) - Remove [3x]
- Underbody Rear Air Deflector Nut- Right Side (4) - Remove [2x]
- Underbody Rear Air Deflector- Right Side (5) - Remove
Underbody Front Air Deflector Bolt- Right Side (1) - Remove [6x]
- Underbody Front Air Deflector Nut- Right Side (2) - Remove [5x]
- Transmission Fluid Cooler Pipe Bracket Bolt- Right Side (3) - Remove [2x]
- Underbody Rear Air Deflector Bolt- Right Side (4) - Remove [2x]
- Underbody Front Air Deflector- Right Side (5) - Remove
Underbody Front Air Deflector Bolt- Left Side (1) - Remove [6x]
- Underbody Front Air Deflector Nut- Left Side (2) - Remove [5x]
- Transmission Fluid Cooler Pipe Bracket Bolt- Left Side (3) - Remove [2x]
- Underbody Rear Air Deflector Bolt- Left Side (4) - Remove [2x]
- Underbody Front Air Deflector- Left Side (5) - Remove
Floor Panel Number 4 Cross Bar Reinforcement Bolt (1) - Remove [6x]
- Floor Panel Reinforcement (2) - Remove
Catalytic Converter Nut (1) - Remove [2x]
Exhaust Pipe Clamp (1) - Loosen [2x]
Exhaust Muffler (1) @ Exhaust Intermediate Pipe Insulator - Left Side (2) - Separate [2x]
Exhaust Muffler (1) @ Exhaust Intermediate Pipe Insulator - Right Side (2) - Separate [2x]
Electrical Connector (1) - Disconnect
Electrical Connector (1) - Disconnect
- NOTE:
The rear bumper fascia is removed for illustration purposes only.
Exhaust Muffler Hanger Bracket Nut (1) - Remove [4x]
With the aid of an assistant, remove the exhaust muffler (1).
- Catalytic Converter Gasket (2) Remove and DISCARD
Remove the 4 rear spring pins (1).
- Rear Suspension Lower Control Arm Cover (2) - Remove
- Have an assistant apply the brakes.
- CAUTION:
DO NOT use air tools to remove the wheel drive shaft nut. Damage to the wheel drive shaft threads could occur. Use hand tools only.
Rear Wheel Drive Shaft Nut (1) - Remove and DISCARD
Install the DT-45859 Axle Remover (1) to the rear wheel hub and secure with 3 wheel nuts (2) hand tightened.
- Using the DT-45859 Axle Remover (1), release the rear wheel drive shaft from the rear wheel hub.
- Remove the 3 wheel nuts (2) and the DT-45859 Axle Remover (1) from the rear wheel hub.
- NOTE:
The rear wheel drive shaft universal joint retainer (1) and washers (2) are serviced as a rear wheel drive shaft universal joint retainer kit consisting of 2 bolts and 1 washer.
Remove and DISCARD the 6 rear wheel drive shaft universal joint retainer (1).
- Remove and DISCARD the 3 wheel drive shaft flange washers (2).
Rear Wheel Drive Shaft (1) - Remove
Rear Wheel Drive Shaft Washer (1) - Remove and DISCARD