Installation Procedure

WARNING: This page is about a different car, the 2022 Cadillac CT4. However, it is still accessible from the selected car via links, so may be relevant.

Courtesy of GENERAL MOTORS COMPANY

Rear Wheel Drive Shaft Washer (1) - Install NEW
Courtesy of GENERAL MOTORS COMPANY

Rear Wheel Drive Shaft (1) - Install
Courtesy of GENERAL MOTORS COMPANY

NOTE:
The rear wheel drive shaft universal joint retainer (1) and washers (2) are serviced as a rear wheel drive shaft universal joint retainer kit consisting of 2 bolts and 1 washer.

Due to the unknown shelf life, prepare the 6 NEW rear wheel drive shaft universal joint retainer (1) for installation as follows:
1. Remove any loose cured adhesive from the external threads of the components using a lint free cloth.
2. Thread the cleaned components into the internal mating threads and remove to loosen trapped cured adhesive.
3. Apply thread locking adhesive to the external threads of the components. Adhesives, Fluids, Lubricants, and Sealers
4. Ensure there are no gaps in the thread locking adhesive once applied to the component.
Install 3 NEW wheel drive shaft washers (2).

CAUTION:

This vehicle is equipped with torque-to-yield or single use fasteners. Install a NEW torque-to-yield or single use fastener when installing this component. Failure to replace the torque-to-yield or single use fastener could cause damage to the vehicle or component.

CAUTION:

Refer to Fastener Caution .

Install and tighten the 6 rear wheel drive shaft universal joint retainer (1) in a crisscross pattern. Fastener Specifications
Have an assistant apply the brakes.
Courtesy of GENERAL MOTORS COMPANY

Rear Wheel Drive Shaft Nut (1) - Install NEW and tighten - Fastener Specifications
Install the right rear tire and wheel assembly. Tire and Wheel Removal and Installation
Inspect the exhaust system for leaks.
Remove the support and lower the vehicle.