LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2021 >> CT4 Sport, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 53 (Tires And Wheels) >> Repair Instructions >> Tire Dismounting and Mounting >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2022 Cadillac CT4. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise and support the vehicle. Lifting and Jacking the Vehicle
  2. Remove the tire and wheel assembly. Tire and Wheel Removal and Installation 
  3. Remove the valve core and release the air pressure.
  4. Deflate the tire completely.
    5. NOTE:

    Rim-clamp touchless tire changers are recommended.

  5. Use the tire changing machine to remove the tire from the wheel following the manufacturer specific directions for the tire changing machine being used.
    6. CAUTION:

    Failure to position valve stem in proper position while dismounting and mounting the tire may result in the TPM sensor to become damaged.

  6. When separating the tire bead from the wheel, do not allow the bead breaker to contact the valve stem/TPM sensor as they will be damaged.
  7. Position the tire machine removal head to the outer tire bead so as it will operate without contacting the valve stem/TPM sensor.
  8. Using the tire changing machine, remove the outer tire bead from the wheel.
  9. Position the tire machine removal head to the outer tire bead so as it will operate without contacting the valve stem/TPM sensor.
  10. Using the tire changing machine, remove the inner tire bead from the wheel and remove the tire.
    11. NOTE:

    Refer to information on the tire sealant Material Safety Data Sheet and follow guidelines for handling and disposal.

  11. If a tire sealant product was used/found within the tire, and the tire is repairable, use a mild dish soap, clean water and shop cloths to remove the sealant residue.
  12. If a confirmed GM approved tire sealant product has been used/found within the tire, use a mild dish soap, clean water and shop cloths to remove the sealant residue from the tire pressure indicator sensor.
  13. If a tire sealant product was used/found within the tire, and it cannot be confirmed that a GM approved product was used, replace the tire pressure indicator sensor. Tire Pressure Indicator Sensor Replacement (Snap In Style) , or Tire Pressure Indicator Sensor Replacement (Clamp In Style)
  14. Use medium coarseness steel wool to remove any rubber or corrosion from the wheel bead seats.
  15. Inspect the tire and wheel for any damage, replace as necessary.
scientia non olet · About LEMON Manuals