Removal Procedure
In order to avoid being burned, do not service the exhaust system while it is still hot. Service the system when it is cool.
Avoid contact with HOT components. Wear safety glasses and protective gloves to avoid personal injury.
- Remove the oil fill cap.
Intake Manifold Cover Bolt (1) - Remove [2x]
- Lift up on the front of the intake manifold cover (2).
Intake Manifold Cover (1) @ Upper Intake Manifold Bracket (2) - Remove
Air Cleaner Outlet Duct Clamp (1) - Loosen [2x]
- Evaporative Emission Canister Purge Tube (2) - Disconnect - Plastic Collar Quick Connect Fitting Service
- Positive Crankcase Ventilation Tube (3) - Disconnect - Plastic Collar Quick Connect Fitting Service
- Disconnect the electrical connector.
Air Cleaner Outlet Duct (1) - Remove
- Disconnect the electrical connector and remove all wiring harnesses from the air cleaner assembly.
Air Cleaner Bolt (1) - Remove
Air Cleaner Assembly (1) - Remove
Disconnect and reposition electrical connectors as necessary.
- Using the appropriate tool, remove the heated oxygen sensor (1).
Turbocharger Heat Shield Bolt (1) - Remove [2x]
Turbocharger Heat Shield Bolt (1) - Remove [2x]
Turbocharger Heat Shield (1) - Remove
- Raise and support the vehicle. Lifting and Jacking the Vehicle
- Disconnect and reposition electrical connectors as necessary.
- Using the appropriate tool, remove the heated oxygen sensor (1).
Floor Panel Number 4 Cross Bar Reinforcement Bolt (1) - Remove [6x]
- Floor Panel Reinforcement (2) - Remove
Catalytic Converter Nut (1) - Remove [2x]
Electrical Connector (1) @ Exhaust Control Valve Actuator - Disconnect [2x]
Exhaust Muffler (1) @ Exhaust Intermediate Pipe Insulator-Left Side (2) - Separate
- Exhaust Muffler (1) @ Exhaust Rear Muffler Insulator-Left Side (3) - Separate
Exhaust Muffler (1) @ Exhaust Intermediate Pipe Insulator-Right Side (2) - Separate
- Exhaust Muffler (1) @ Exhaust Rear Muffler Insulator-Right Side (3) - Separate
Exhaust Muffler (1) - Remove
- Catalytic Converter Gasket (2) - Remove and DISCARD
Front Crossmember Brace Nut (1) - Remove [4x]
- Front Crossmember Brace (2) - Remove
Exhaust Pipe Clamp (1) - Loosen
Catalytic Converter Brace Bracket Nut (1) - Remove [2x]
- Catalytic Converter Brace Bolt (2) - Remove [2x]
- Catalytic Converter Brace (3) - Remove
Warm Up Three-Way Catalytic Converter (1) - Remove
- Exhaust Pipe Clamp (2) - Remove and DISCARD
- Catalytic Converter Gasket (3) - Remove and DISCARD
Refer to Heated Oxygen and Oxygen Sensor Caution .
The use of excessive force may damage the threads in the exhaust manifold/pipe.
The heated oxygen sensor MAY be difficult to remove when the engine temperature is less than 48°C (120°F).
The heated oxygen sensor in-line connector and louvered end MUST be kept clear of all grease, dirt, and other contaminants. Do NOT use cleaning solvents of any type. Do NOT drop or roughly handle the sensor.
The heated oxygen sensor MAY be difficult to remove when the engine temperature is less than 48°C (120°F).
The heated oxygen sensor in-line connector and louvered end MUST be kept clear of all grease, dirt, and other contaminants. Do NOT use cleaning solvents of any type. Do NOT drop or roughly handle the sensor.