Removal Procedure

WARNING: This page is about a different car, the 2022 Cadillac CT4. However, it is still accessible from the selected car via links, so may be relevant.

Courtesy of GENERAL MOTORS COMPANY

NOTE:
Use a small flat-bladed tool to disengage integral tabs on cargo tie down loop bolt cap

Cargo Tie Down Loop Bolt Cap (1) - Remove [2x]
Cargo Tie Down Loop Bolt (2) - Remove [2x]
Cargo Tie Down Loop (3) - Remove [2x]
Courtesy of GENERAL MOTORS COMPANY

Rear Compartment Floor Panel Trim (1) - Remove
Courtesy of GENERAL MOTORS COMPANY

Use a small flat-bladed tool to disengage integral tabs on rear end trim finish panel opening cover (1).
Rear End Trim Finish Panel Opening Cover (1) - Remove
Courtesy of GENERAL MOTORS COMPANY

With a flat bladed plastic trim tool, disengage the integral clips.
Rear End Trim Finish Panel (1) - Remove
Courtesy of GENERAL MOTORS COMPANY

NOTE:
Carefully manipulate the deck lid hinge opening of the rear compartment side trim past the hinge cover.

Rear Compartment Side Trim Insulator Retainer (1) - Remove [4x]
Rear Compartment Side Trim-Left Side (2) - Remove
Disconnect the transfer case control module electrical connectors.
Courtesy of GENERAL MOTORS COMPANY

Release the 2 retaining tabs (1) then remove the transfer case control module (2).