Circuit/System Verification
WARNING: This page is about a different car, the 2022 Cadillac CT5. However, it is still accessible from the selected car via links, so may be relevant.
- Ignition - On/Vehicle - In Service Mode
- Verify DTC P2615, P2616 is not set.
- If any of the DTCs are set
- Ignition/Vehicle - Off
- Verify the following conditions do not exist:
- Corrosion@Electrical Connector@K20 Engine Control Module
- Short between the circuits@Electrical Connector@K20 Engine Control Module
- If a condition exists - Repair or replace as necessary
- If none of the conditions exists - Replace the appropriate component: K20 Engine Control Module
- Go to next step: If none of the DTCs are set
- All OK.