Memory Store and Recall Conditions

Memory Store Preconditions:

• RUN power mode
• No Stuck or Active Switches (seat, mirror, column, HUD)
• No SIR Disable
• No Load Shed 3
• No output motor drive faults detected
• No position plausibility faults detected
• No child lockout - rear
• Not limit switch fault
• No memory switch fault
• Memory ID is 1 or 2

Memory Recall Preconditions:

• No Stuck or Active Switches (seat, mirror, column, HUD)
• No SIR Disable
• No Load Shed 3
• No output motor drive faults detected
• No position plausibility faults detected
• No child lockout - rear
• Not limit switch fault
• No memory switch fault
• Memory ID is 1 or 2
• LIN communications Active
• Not currently performing a memory store
• A position has been saved to the recalled memory position

Memory Recall Termination Conditions:

• Precondition no longer met
• Active memory button changed
• Recall completed
• Exceed the max allowed recall time (30 seconds)
• OTA Programming Requested

Auto Memory Recall Preconditions:

NOTE:

Auto Memory Recall is suspended during Start power mode.

• Valid Memory ID and Driver ID
• Valid Power Mode
• No Active or Stuck Switches
• No SIR disable
• Vehicle is Stopped
• No Load Shed 3
• No ASIL - A output fault detected
• No position plausibility faults detected
• No child lockout - rear
• Not limit switch fault
• No memory switch fault
• A position has been saved to the recalled memory position
• Enabled for Current Driver

Auto Memory Recall Termination Conditions:

• Precondition no longer met, except being Parked
• Exceed any recall completion times
• Ignition On terminates Seat Exit Memory
• Ignition Off terminates Seat Entry Memory
• OTA Programming Requested

Memory Recall Termination Data Displays: 

The termination causes can be viewed through the Seat Memory Recall History data displays. The following are possible memory recall termination causes:

• No Recall Requested
• Seat Entry/Exit Recall Completed
• Memory Button 1 Recall Initiated
• Memory Button 1 Recall Completed
• Memory Button 2 Recall Initiated
• Memory Button 2 Recall Completed
• Memory Button Exit Recall Initiated
• Memory Button Exit Recall Completed
• Terminated by Other then following
• Memory switch stuck or Invalid
• Memory Switch (Not including SET) out of Range
• Memory SET switch Active or 1, 2, Exit switch changed
• Seat Switch Active or Stuck
• Mirror Switch Active or Stuck
• HUD Switch Active or Stuck
• No Position 1 stored
• No Position 2 Stored
• No Position Exit Stored
• Load Shed 3
• Sir Disabled
• Limit Switch Active or Fault
• Seat Entry - Not Parked terminated
• Invalid Power Mode
• Seat Forward Rearward Motor Control Fault
• Seat Front Up/Down Motor Control Fault
• Seat Rear Up/Down Motor Control Fault
• Recline Forward Rearward Motor Control Fault
• Seat Front Up/Down Motor Position Fault
• Seat Rear Up/Down Motor Position Fault
• Recline Forward Rearward Motor Position Fault