Installation Procedure
WARNING: This page is about a different car, the 2022 Cadillac CT5. However, it is still accessible from the selected car via links, so may be relevant.
Clutch Master Cylinder(3) - Install
- Clutch Pedal Lever Pin Retainer(2) - Install
- Clutch Master Cylinder Bolt(1) - Install and tighten[2x] -
Brake Pedal(1) - Install - Brake Pedal Removal and Installation (without MJK)Brake Pedal Removal and Installation (with MJK)
Remove the plug from the clutch master cylinder reservoir hose (2) outlet.
- Clutch Master Cylinder Reservoir Hose(2) - Install
- Remove the plug from the clutch master cylinder pipe (3) inlet.
- Clutch Master Cylinder Pipe(3)@Clutch Master Cylinder - Install
- Retainer(1)@Clutch Master Cylinder - Engage
- Enable the SIR System. SIR Disabling and Enabling .
- Calibrate the brake pedal position sensor. Brake Pedal Position Sensor Calibration
- Bleed the clutch hydraulic system. Hydraulic Clutch System Bleeding
- Perform the clutch pedal position sensor learn procedure. Clutch Pedal Position Learn
NOTE:
Ensure correct clutch pushrod eyelet orientation and the retainer clip is fully engaged.