Removal Procedure
WARNING: This page is about a different car, the 2022 Cadillac CT5. However, it is still accessible from the selected car via links, so may be relevant.
- Set the electronic parking brake in service mode. Parking Brake Service Mode Selection
- Raise and support the vehicle. Lifting and Jacking the Vehicle
- Remove the rear tire and wheel assembly. Tire and Wheel Removal and Installation (without J57) , or Tire and Wheel Removal and Installation (with J57)
- NOTE:
Typical rear rotor is shown, actual rotor will vary based on RPO.
Parking Brake Caliper Pin Clip (1) - Remove [2x]
- NOTE:
Typical rear rotor is shown, actual rotor will vary based on RPO.
Parking Brake Caliper Pin (2) - Remove [2x]
- Parking Brake Caliper Pad Spring (1) - Remove
- NOTE:
Typical rear rotor is shown, actual rotor will vary based on RPO.
Parking Brake Caliper Inner Pad (1) - Remove
- Parking Brake Caliper Outer Pad (2) - Remove
- NOTE:
Typical rear rotor is shown, actual rotor will vary based on RPO.
Disconnect the parking brake actuator electrical connector.
- Parking Brake Bolt (1) - Remove [2x]
- Parking Brake Caliper (2) - Remove