LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2021 >> CT4 Sport, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 331 (Park Brake) >> Repair Instructions >> Parking Brake Caliper Replacement (J57, J6H) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2022 Cadillac CT5. However, it is still accessible from the selected car via links, so may be relevant.
  1. GM5877737Courtesy of GENERAL MOTORS COMPANY
    NOTE:

    Typical rear rotor is shown, actual rotor will vary based on RPO.

    Parking Brake Caliper (2) - Install

  2. Parking Brake Bolt (1) - Install and tighten [2x] 58 N.m (43 lb ft)
  3. Connect the parking brake actuator electrical connector.
  4. GM5877734Courtesy of GENERAL MOTORS COMPANY
    NOTE:

    Typical rear rotor is shown, actual rotor will vary based on RPO.

    Parking Brake Caliper Outer Pad (2) - Install

  5. Parking Brake Caliper Inner Pad (1) - Install
  6. GM5877736Courtesy of GENERAL MOTORS COMPANY
    NOTE:

    Typical rear rotor is shown, actual rotor will vary based on RPO.

    Parking Brake Caliper Pad Spring (1) - Install

  7. Parking Brake Caliper Pin (2) - Install [2x]
  8. GM5877735Courtesy of GENERAL MOTORS COMPANY
    NOTE:

    Typical rear rotor is shown, actual rotor will vary based on RPO.

    Parking Brake Caliper Pin Clip (1) - Install [2x]

  9. Install the rear tire and wheel assembly. Tire and Wheel Removal and Installation (without J57) , or Tire and Wheel Removal and Installation (with J57)
  10. Remove the support and lower the vehicle.
  11. Calibrate the electronic parking brake. Park Brake Calibration