Removal Procedure
WARNING: This page is about a different car, the 2022 Cadillac CT5. However, it is still accessible from the selected car via links, so may be relevant.
- Set the parking brake in Service Mode.
- Install a scan tool.
- Turn the ignition ON with the engine OFF.
- Select Electronic Brake Control Module.
- Select Control Functions.
- Select Rear Brake Caliper Piston Retract.
NOTE:Do NOT apply any brake pressure during this step.
- Raise and support the vehicle. Lifting and Jacking the Vehicle .
- Remove the rear tire and wheel assembly. Tire and Wheel Removal and Installation (without J57) , or Tire and Wheel Removal and Installation (with J57) .
Parking Brake Actuator Bolt (1) - Remove [2x]
Electrical Connector (1) @ Rear Parking Brake Actuator - Disconnect
- Retainer (2) @ Rear Parking Brake Actuator - Remove
Rear Parking Brake Actuator (1) - Remove
- Rear Parking Brake Actuator Lever Seal (2) - Remove and DISCARD