Installation Procedure
WARNING: This page is about a different car, the 2022 Cadillac CT5. However, it is still accessible from the selected car via links, so may be relevant.
Install the rear wheel speed sensor into the vehicle.
- Retainer (2) - Install
- Connect the electrical connector. (1)
Retainer (1) - Install [2x]
Retainer (1) - Install [2x]
{If equipped} Rear Disc Brake Pad Wear Sensor (2) @Retainer (1) - Install [2x]
Rear Wheel Speed Sensor (2) @Knuckle - Install
- Rear Wheel Speed Sensor Bolt (1) - Install and tighten [2x]9 N.m (80 lb in)
- Install the rear tire and wheel assembly. Tire and Wheel Removal and Installation (without J57)Tire and Wheel Removal and Installation (with J57)
- Remove the support and lower the vehicle.
CAUTION: