Circuit/System Verification
WARNING: This page is about a different car, the 2022 Cadillac CT5. However, it is still accessible from the selected car via links, so may be relevant.
- Verify DTC C0061, B0063, C0551 is not set.@K36 Restraints Control Module
- If DTC C0061, B0063, C0551 is set
Perform the following learn procedure:Vehicle Dynamic Sensor Offset Calibration
- Go to next step: If the DTC is not set
- If DTC C0061, B0063, C0551 is set
- Verify DTC C0061, B0063, C0551 is not set.@K160 Brake System Control Module
- If any of the DTCs are set
- Replace the component: K36 Restraints Control Module
- Under normal operating conditions:Verify the DTC does not set.
- If the DTC sets - Replace the component:K160 Brake System Control Module
- Go to next step: If the DTC is not set
- All OK.
- Go to next step: If none of the DTCs are set
- All OK.