Installation Procedure
WARNING: This page is about a different car, the 2022 Cadillac CT5. However, it is still accessible from the selected car via links, so may be relevant.
- CAUTION:
This vehicle is equipped with torque-to-yield or single use fasteners. Install a NEW torque-to-yield or single use fastener when installing this component. Failure to replace the torque-to-yield or single use fastener could cause damage to the vehicle or component.
Rear Suspension Link Inner Bolt (3) - Install NEW
- Rear Suspension Link Inner Washer (2) - Install
- Rear Suspension Link Inner Nut (1) - Install, but do NOT tighten
Rotate the rear suspension link inner bolt (2) as necessary to achieve the correct toe setting.
- Tighten the rear suspension link inner nut (1) only enough to prevent the loss of the toe setting.
- Verify the toe measurement, readjust if necessary.
- Rear Suspension Link Inner Nut (1) - Tighten
- First Pass: 70 N.m (52 lb ft)
- Final Pass: 90 - 100 degrees
- Remove the support and lower the vehicle.
CAUTION:
Refer to Fastener Caution .