Installation Procedure

WARNING: This page is about a different car, the 2022 Cadillac CT5. However, it is still accessible from the selected car via links, so may be relevant.

Courtesy of GENERAL MOTORS COMPANY

Turbocharger Tube Seal (4) - Install NEW
Turbocharger Oil Return Pipe Seal (3) - Install NEW [2x]
Turbocharger Oil Feed Pipe Gasket (2) - Install NEW

CAUTION:

When installing a quick-connect turbocharger oil feed pipe, ensure that the oil feed pipe is fully secured into the oil feed pipe fitting. An audible click will be heard when the oil feed pipe is seated. If the oil feed pipe is not fully seated, an oil leak can occur in certain RPM ranges and will cause significant component and/or vehicle damage. Due to the possibility of significant component and/or vehicle damage from an oil feed pipe leak, it is necessary to start the engine and inspect for signs of leakage around the connections after performing the repair.

NOTE:

Do not bend the oil feed pipe.

Install the lower section of the turbocharger oil feed pipe (1) to the engine block first.
Courtesy of GENERAL MOTORS COMPANY

NOTE:
The turbocharger oil feed pipe clip is not serviced separately, if damaged must replace the turbocharger oil feed pipe fitting.

Turbocharger Oil Feed Pipe Clip (1) - Install
Courtesy of GENERAL MOTORS COMPANY

CAUTION:
Refer to Fastener Caution .

Turbocharger Oil Feed Pipe Bolt (1) - Install and tighten [2x] 8.5 N.m (75 lb in)
Courtesy of GENERAL MOTORS COMPANY

Engine Mount Bracket - Left Side (2) - Install - Engine Mount Bracket Replacement - Left Side (AWD) , or Engine Mount Bracket Replacement - Left Side (RWD)