LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2021 >> CT4 Sport, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 326 (Engine Mechanical - 3.0L (LGY) - Repair Instructions) >> Repair Instructions >> Camshaft Replacement - Right Side >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2022 Cadillac CT5. However, it is still accessible from the selected car via links, so may be relevant.
  1. GM5520693Courtesy of GENERAL MOTORS COMPANY
    NOTE:

    Laser Etched or ID flats - Correct Camshaft Location - Bank 1 (F)

    Exhaust Camshaft - Right Side (1) - Install

    1. Make sure the camshaft flats with laser etched markings are straight up in relation to the cylinder head and that the crankshaft is in the stage 2 position. The crankshaft key way will be at approximately the 3 o'clock position. Timing Chain Alignment Diagram
    2. Ensure the flat is facing upward when installed to help when installing timing chains.
    2. NOTE:

    Laser Etched or ID flats - Correct Camshaft Location - Bank 1 (E)

  2. Intake Camshaft - Right Side (2) - Install
    1. Make sure the camshaft flats with laser etched markings are straight up in relation to the cylinder head and that the crankshaft is in the stage 2 position. The crankshaft key way will be at approximately the 3 o'clock position. Timing Chain Alignment Diagram
    2. Ensure the flat is facing upward when installed to help when installing timing chains.
  3. GM5520695Courtesy of GENERAL MOTORS COMPANY
    NOTE:
    • Many internal engine components will develop specific wear patterns on their friction surfaces.
    • Components MUST be separated, marked, or organized in a way to ensure installation to their original location and position. Take precautions in order to prevent interchanging of parts.
    • Tag or mark each part immediately when removed. Indicate location, direction, or orientation when necessary.

    Dowel Pin (1) - Install [2x]

  4. Camshaft Bearing Cap - Intermediate (2) - Install
  5. Camshaft Bearing Cap (3) - Install
  6. Camshaft Bearing Cap (4) - Install [2x]
  7. Camshaft Bearing Cap Bolt (5) - Install and hand tighten [14x]
  8. GM5520697Courtesy of GENERAL MOTORS COMPANY
  9. Camshaft Bearing Cap (2) - Install
  10. Camshaft Carrier Bolt (3) - Install and hand tighten [4x]
  11. Camshaft Bearing Cap Bolt (4) - Install and hand tighten
  12. Fig 1: Identifying Camshaft Bearing Cap Bolts With Tightening Sequence - Right Side
    GM5518234Courtesy of GENERAL MOTORS COMPANY
    CAUTION:

    Refer to Fastener Caution .

  13. Camshaft Bearing Cap Bolt (3) - Tighten in sequence
    1. First Pass: 6 N.m (53 lb in)
    2. Final Pass: 45 degrees
  14. GM4169709Courtesy of GENERAL MOTORS COMPANY

    Camshaft Position Actuator (1) - Install [2x] - Camshaft Position Actuator Replacement - Bank 1 

scientia non olet · About LEMON Manuals