LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2021 >> CT4 Sport, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 325 (Engine Mechanical - 2.0L (LSY) - Repair Instructions) >> Repair Instructions >> Engine Block Overhaul >> Engine Block Assemble Procedure

Engine Block Assemble Procedure

WARNING: This page is about a different car, the 2022 Cadillac CT5. However, it is still accessible from the selected car via links, so may be relevant.
  1. GM5028823Courtesy of GENERAL MOTORS COMPANY

    Oil Flow Check Valve Seal (1) - Install NEW

  2. Oil Flow Check Valve (2) - Install
  3. GM5028819Courtesy of GENERAL MOTORS COMPANY

    Piston Oil Nozzle (1) - Install [4x]

    4. CAUTION:

    Fastener Caution

  4. Piston Oil Nozzle Bolt (2) - Install and tighten [4x] - Fastener Specifications
  5. GM5028818Courtesy of GENERAL MOTORS COMPANY

    Cylinder Head Locating Pin (1) - Install [2x] - use KM-266  Remover/Installer

  6. GM5028816Courtesy of GENERAL MOTORS COMPANY

    Engine Block Core Hole Plug (1) - Install

  7. Guide Pin (2, 3) - Install [4x]
  8. GM5926602Courtesy of GENERAL MOTORS COMPANY
    CAUTION:

    Refer to Component Fastener Tightening Caution .

    Engine Coolant Temperature Sensor (1) - Install and tighten - Fastener Specifications

  9. Starter Locating Pin (2) - Install [2x] - use J-26269  Remover/Installer
  10. {with K05} Install and tighten the engine coolant heater (4). Fastener Specifications
  11. {without K05} Install and tighten the engine coolant heater hole plug (3). Fastener Specifications
scientia non olet · About LEMON Manuals