Installation Procedure
WARNING: This page is about a different car, the 2022 Cadillac CT5. However, it is still accessible from the selected car via links, so may be relevant.
If the balancer chain tensioner (1) needs to be assembled, install the retaining spring (2) and the plunger (3), then install the EN-955-10-A Locking Pin to reset the tensioner.
Balancer Chain Tensioner (1) - Install
- Balancer Chain Tensioner Bolt (2) - Install and tighten [2x] - 15 N.m (11 lb ft)
EN-955-10-A Locking Pin (2) - Remove
- Crankshaft Rear Oil Seal Housing - Install - Crankshaft Rear Oil Seal Housing Replacement