Installation Procedure
WARNING: This page is about a different car, the 2022 Cadillac CT5. However, it is still accessible from the selected car via links, so may be relevant.
Transmission Fluid Cooler Inlet and Outlet Pipe (1) - Install
- Transmission Fluid Cooler Seal (2) - Install NEW
- Transmission Fluid Cooler Inlet and Outlet Pipe (1) - Connect
- Transmission Fluid Cooler Pipe Nut (3) - Install and tighten to 22 N.m (16 lb ft)
Transmission Fluid Cooler Pipe Bracket Bolt (1) - Install and tighten to 9 N.m (80 lb in)
Transmission Fluid Cooler Inlet and Outlet Pipe (2) - Connect
- Retaining Clip (3) @ Transmission Fluid Auxiliary Cooler Inlet Pipe (1) - Engage
Transmission Fluid Cooler Inlet and Outlet Pipe (5) - Connect
- Retaining Clip (4) - Engage
- Transmission Fluid Cooler Pipe Bracket (3) - Install
- Transmission Fluid Cooler Pipe Bracket Bolt (2) - Install and tighten to 9 N.m (80 lb in)
- Transmission Fluid Cooler Pipe Bolt (1) - Install and tighten to 22 N.m (16 lb ft)
Transmission Fluid Cooler Pipe Nut (1) - Install and tighten to 22 N.m (16 lb ft)
Transmission Fluid Cooler Pipe Bracket Bolt (1) - Install and tighten to 9 N.m (80 lb in)
Front Cradle Shear Plate (1) - Install - Front Cradle Shear Plate Replacement (Blackwing)
Front Bumper Fascia (1) - Install - Front Bumper Fascia Replacement (with Blackwing)
- Lower the vehicle.
- Check the transmission fluid level. Transmission Fluid Level and Condition Check
- Inspect for transmission fluid leaks. Fluid Leak Diagnosis
CAUTION:
Refer to Fastener Caution .