Installation Procedure
WARNING: This page is about a different car, the 2022 Cadillac CT5. However, it is still accessible from the selected car via links, so may be relevant.
Auxiliary Generator Battery Jumper Cable (1) - Install
- Raise and support the vehicle. Lifting and Jacking the Vehicle
Auxiliary Generator Battery Jumper Cable (1) - Install
- Battery Positive Cable Nut (2) @Starter Solenoid - Install - Starter Replacement (LGY)
Starter (2) - Install
- Starter Bolt (4) - Install - Starter Replacement (LGY)
- Starter Bolt (1) - Install - Starter Replacement (LGY)
- Battery Cable Terminal Bolt (3) - Install - Starter Replacement (LGY)
Starter Heat Shield (2) - Install
- Starter Heat Shield Bolt (1) - Install [2x] - Starter Heat Shield Replacement (LGY)
Auxiliary Generator Battery Jumper Cable (2) - Install
- Battery Negative Cable Ground Stud (1) - Install and Tighten 45 N.m (33 lb ft)
Retainer (1) - Install [3x]
- Electrical Connector (2) - Connect
- Install the left side warm up three-way catalytic converter. Warm Up Three-Way Catalytic Converter Replacement - Left Side (LGY)
Front Compartment Air Deflector (1) - Install - Front Compartment Air Deflector Replacement (AWD) , or Front Compartment Air Deflector Replacement (RWD) , or Front Compartment Air Deflector Replacement (Blackwing)
- Lower the vehicle.
Auxiliary Generator Battery Jumper Cable (5) - Install
- Battery Positive Cable Nut (2) - Install - Engine Wiring Harness Fuse Block Bracket Replacement
- Battery Negative Cable Ground Bolt (3) - Install and tighten 22 N.m (16 lb ft)
- Retainer (4) - Install [5x]
- Fuse Block Cover (1) - Install
- Connect the negative battery cable. Battery Negative Cable Disconnection and Connection
CAUTION:
Refer to Fastener Caution