Hood Primary and Secondary Latch Replacement

WARNING: This page is about a different car, the 2022 Cadillac CT5. However, it is still accessible from the selected car via links, so may be relevant.

Courtesy of GENERAL MOTORS COMPANY

NOTE: Callouts in the following chart represent components shown in graphic above.

Callout	Component Name
Preliminary Procedures Front Compartment Front Sight Shield Replacement Radiator Air Upper Baffle Replacement (LSY) , or Radiator Air Upper Baffle Replacement (LGY) , or Radiator Air Upper Baffle Replacement (LT4)
1	Hood Primary and Secondary Latch Bolt [2x] CAUTION: Refer to Fastener Caution . Tighten 9 N.m (80 lb in)
2	Hood Primary and Secondary Latch Procedure Disconnect the hood primary latch release cable from the hood primary and secondary latch. Disconnect the electrical connector from under the tie bar. Align the hood primary and secondary latch if necessary.

Callout

Component Name

Preliminary Procedures

Front Compartment Front Sight Shield Replacement
Radiator Air Upper Baffle Replacement (LSY) , or Radiator Air Upper Baffle Replacement (LGY) , or Radiator Air Upper Baffle Replacement (LT4)

Hood Primary and Secondary Latch Bolt [2x]

CAUTION:

Refer to Fastener Caution .

Tighten
9 N.m (80 lb in)

Hood Primary and Secondary Latch

Procedure

Disconnect the hood primary latch release cable from the hood primary and secondary latch.
Disconnect the electrical connector from under the tie bar.
Align the hood primary and secondary latch if necessary.