Removal Procedure
WARNING: This page is about a different car, the 2022 Cadillac CT5. However, it is still accessible from the selected car via links, so may be relevant.
- Quarter Upper Trim Panel - Remove - Quarter Upper Trim Panel Replacement
- Disconnect the defrost tab electrical connectors.
High Mount Stop Lamp (2) - Remove - High Mount Stop Lamp Replacement
- Apply a double layer of masking tape around the perimeter of the painted surfaces.
- Cover the seats and carpeting to protect from broken glass.
- NOTE:
Keep the cutting edge of the tool against the rear window. This will allow the urethane adhesive to be separated from the window.
Use BO-24402-A Glass Sealant Remover (1) or equivalent in order to remove the window.
- Leave a base of urethane on the pinchweld flange.
- The only suitable lubrication is clear water.
With an assistant, remove the locator pins (1) and rear window (2) from the vehicle.
- Transfer components as necessary.
WARNING:
Refer to Cracked Window Warning .
WARNING:
Refer to Glass and Sheet Metal Handling Warning .
NOTE:
If reusing the rear window, use care when disconnecting the defrost tabs to not twist or pull excessively which may cause the defrost tab to separate from the rear window.