Installation Procedure

WARNING: This page is about a different car, the 2022 Cadillac CT5. However, it is still accessible from the selected car via links, so may be relevant.

Courtesy of GENERAL MOTORS COMPANY

CAUTION:
Ensure the seat heater is not folded or creased during installation as damage to the internal circuitry may occur, causing performance issues and damage to seat components.

If replacing the front seat cushion pad (2), install NEW front seat cushion heater and front seat vent fan mat, if equipped.
Front Seat Cushion Pad (2) - Install
Front Seat Cushion Cover (1) - Install
Connect the J-channel retainers.
Courtesy of GENERAL MOTORS COMPANY

{If equipped} Front Seat Cushion Ventilation Blower (1) - Install - Front Seat Cushion Ventilation Blower Replacement
{If equipped} Front Seat Cushion Front Extension Frame - Install - Front Seat Cushion Front Extension Frame Replacement
Courtesy of GENERAL MOTORS COMPANY

Front Seat Inner Adjuster Front Finish Cover (2) - Install - Front Seat Inner Adjuster Front Finish Cover Replacement
Courtesy of GENERAL MOTORS COMPANY

Front Seat Cushion Front Finish Cover (3) - Install - Front Seat Cushion Front Finish Cover Replacement (Seat Cushion)
Courtesy of GENERAL MOTORS COMPANY

Front Seat Cushion Outer Finish Cover (3) - Install - Front Seat Cushion Outer Finish Cover Replacement
Courtesy of GENERAL MOTORS COMPANY

Front Seat (2) - Install - Front Seat Removal and Installation
Enable the SIR System. SIR Disabling and Enabling

NOTE:

The Regulatory Name for this component because of SAE J1930 is Restraints Occupant Classification System Module.

Perform the necessary programming and setup procedure: Control Module References